Nowadays, there are many engineering projects, and the concrete mixing station is a commonly used mixing equipment in the project. However, in operation and operation, the small mixing plant can not be started. What are the reasons
1. When the battery of the small mixing station is seriously discharged and the plate and separator are seriously aged, the temporary shutdown will be started every time, but the shutdown time will be longer, or the crankshaft will only rotate for two days when starting. Then you can consider replacing the battery.
2. When the small mixing plant is started, only the electromagnetic switch of the starter can be heard, but the crankshaft will not rotate. This may be caused by the "disconnection" of the battery.
3. When the rod and the clamp are in poor contact and the heat burns, you will find that the starter suddenly weakens with burning rubber smell or electric shock.
4. When the holding coil of the starter electromagnetic switch is connected to the power terminal or the three wires on the key switch are not connected correctly, when the main power switch is turned on, the starter driving gear and flywheel teeth of the concrete mixer will appear. The phenomenon of rings meshing together and rotating.
5. When the meshing cutting surface of the flywheel ring gear of the small mixing plant is deformed, the starter drive gear and the engine flywheel ring gear will produce idling sound when starting.
6. If the concrete mixer starts with a slight "beep" and does not respond, there may be a problem with the start relay.
